Skip to main content
Skip table of contents

Configuring the Report Adapter replication transaction recovery rate

The NexJ Report Adapter is responsible for replicating NexJ CRM transactions to the ad hoc reporting database. If changes fail to synchronize from CRM to the Reporting database due to a transient condition (for example, a network service interruption), they will be queued and retried. The retry rate is controlled by the exponential backoff settings.

You can configure exponential backoff and retry settings for messages failures for ad hoc reports on the Statistics page in NexJ System Admin Console.

To configure backoff and retry settings for the NexJ Report Adapter in a standalone Reporting environment, or in a Reporting environment integrated with NexJ CRM, navigate to the Statistics page in NexJ System Admin Console, select nexj.finance > Administration > Report Adapter, and configure the required settings, which are shown in the following screenshot.

Exponential backoff and retry settings for the Report Adapter

To configure backoff and retry settings for Reporting-only side queues in a standalone Reporting environment, navigate to the Statistics page in NexJ System Admin Console, select nexj.finance > Administration > Reporting > Replication, and configure the required settings, which are shown in the following screenshot.

Exponential backoff and retry settings for Reporting-only side queues

To configure the following settings, enter a new number in the associated Value field:

  • Maximum backoff retries (maximum number)
  • Maximum backoff wait time (in seconds)
  • Minimum backoff wait time (in seconds)

Enabling or disabling the replication of changes from NexJ CRM to Ad Hoc Reporting databases


JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.